Download DIN 976.pdf PDF

TitleDIN 976.pdf
File Size196.8 KB
Total Pages6
Document Text Contents
Page 1

Page 2
DIN 976-1 : 2002-12

1 Scope
This standard specifies dimensions and technical delivery conditions for stud bolts with metric thread made
of steel, stainless steel or nonferrous metal.

2 Normative references
This standard incorporates, by dated or undated reference, provisions from other publications. These norma-
tive references are cited at the appropriate places in the text, and the titles of the publications are listed below.
For dated references, subsequent amendments to or revisions of any of these publications apply to this
standard only when incorporated in it by amendment or revision. For undated references, the latest edition of
the publication referred to applies.

DIN 267-2 Fasteners – Technical delivery conditions – Product grades and tolerances
DIN 267-10 Fasteners – Technical delivery conditions – Hot-dip galvanized components
DIN 4000-2 Tabular layouts of article characteristics for bolts, screws and fit bolts
DIN EN 26157-3 Fasteners – Surface discontinuities – Part 3: Bolts, screws and studs for special require-

ments (ISO 6157-3 : 1988)
DIN EN 28839 Mechanical properties of fasteners – Bolts, screws, studs and nuts made of non-ferrous

metals (ISO 8839 : 1986)
DIN EN ISO 898-1 Mechanical properties of fasteners made of carbon steel and alloy steel – Part 1: Bolts,

screws and studs (ISO 898-1 : 1999)
DIN EN ISO 3269 Fasteners – Acceptance inspection (ISO 3269 : 2000)
DIN EN ISO 3506-1 Mechanical properties of corrosion-resistant stainless steel fasteners – Part 1: Bolts,

screws and studs (ISO 3506-1 : 1997)
DIN EN ISO 4042 Fasteners – Electroplated coatings (ISO 4042 : 1999)
DIN EN ISO 4753 Fasteners – Ends of parts with external ISO metric screw thread (ISO 4753 : 1999)
DIN EN ISO 4759-1 Tolerances for fasteners – Part 1: Bolts, screws, studs and nuts – Product grades A, B

and C (ISO 4759-1 : 2000)
DIN EN ISO 10683 Fasteners – Non-electrolytically applied zinc flake coatings (ISO 10683 : 2000)
DIN ISO 965-1 ISO general purpose metric screw threads — Tolerances – Part 1: Principles and basic

dates (ISO 965-1 : 1998)
DIN ISO 965-2 ISO general purpose metric screw threads — Tolerances – Part 2: Limits of sizes for

general purpose external and internal screw threads – Medium quality (ISO 965-2 : 1998)
ISO 8992:1986 Fasteners – General requirements for bolts, screws, studs and nuts

3 Dimensions
Stud bolt dimensions shall be as given in figures 1 and 2 and table 1.
Type A, with RL type thread end as in DIN EN ISO 4753

Figure 1: Type A stud bolt dimensions (notation)

Type B, with CH type thread end as in DIN EN ISO 4753

Figure 2: Type B stud bolt dimensions (notation)

Similer Documents